Exterior hose bibs run year-round
South Florida’s mild winters mean outdoor faucets stay in regular use nearly all year, which shows up as faster wear compared to climates where they sit unused for months.
24/7 dispatch across Miami-Dade
A dripping, leaking or stuck faucet gets diagnosed at the fixture, whether the cause is a worn cartridge, a failed O-ring, or hardware that has simply corroded.
The handle is fully tight and it still drips. What is going on?
A persistent drip almost never comes from the handle itself. Inside most modern faucets, a cartridge or ceramic disc controls water flow, and once it wears out or a rubber seal degrades, water finds its way past the closed position no matter how tight the handle is turned.
Tightening harder can even make it worse over time by stressing the same worn part, and in some cases it can crack the handle or the valve stem entirely. Replacing the actual cartridge or seal is what stops the drip, not additional force on a part that is not the problem.
Getting the right cartridge for a specific faucet brand and model matters here too, since a mismatched part can look like it fits while still leaking within weeks of being installed. Describing the faucet brand and approximate age ahead of the visit helps us arrive with the correct part the first time.
What we fix
Most of these are resolved with an internal part swap, not a new fixture.
Usually a worn cartridge or seal, replaceable without swapping the whole faucet.
Can be a clogged aerator, a partially closed shut-off valve, or sediment in the line feeding that fixture.
Mineral buildup or corrosion inside the valve body, often resolved without full fixture replacement.
Usually a worn gasket or O-ring at the base connection, a quick fix once the faucet is disassembled.
Usually a loose mounting nut beneath the sink rather than a problem with the faucet itself, tightened from below.

Local factor
Miami’s climate changes how quickly certain faucet hardware wears out.
South Florida’s mild winters mean outdoor faucets stay in regular use nearly all year, which shows up as faster wear compared to climates where they sit unused for months.
Lower-quality faucet internals corrode faster in a consistently humid climate, which is one reason a fixture that would last much longer up north sometimes needs earlier attention here.
Frequently asked
In most cases, yes -- common cartridge and valve types are stocked, and a specific part can usually be sourced quickly if the faucet is less common.
If the body itself is sound and just one internal part has failed, repair is usually the more direct fix. We will tell you honestly if replacement makes more sense.
Yes, exterior fixtures are repaired the same as indoor faucets.
That vibration is often a loose or worn washer inside the valve, an inexpensive fix once identified.
Yes -- even a slow, steady drip adds up to real gallons over a full month, which is one reason it is worth fixing promptly rather than living with it.
If pressure is low at only one faucet, the shut-off valve feeding that fixture is worth checking before assuming the faucet cartridge itself is the cause.
Related
A faucet problem sometimes overlaps with the system feeding it.

Ready when you are
There is no charge for the estimate. When a pipe will not stop, call rather than type.